Model Number: 6E-CIA-SFS

Calculate Approximate Shipping Cost

Eliminator

1/3 HP Submersible Sump/Effluent Pump

The 6E-CIA-SFS "Eliminator" submersible pump from Little Giant is specifically engineered to handle the tough demanding tasks of wastewater and effluent with high efficiency and long term dependability. For residential and light commercial use, the automatic submersible sump/effluent pump provides reliable and efficient service. Pump has a 1-1/2" FNPT discharge and a 20' maximum head. Cast iron motor housing is oil-filled for lifetime lubrication and rapid heat dissipation.

• 1/3 HP, 115 Volt, 10' Power Cord
• Handles liquid and solid waste materials up to 1/2" diameter solids.
• Epoxy coated cast iron motor housing for corrosion and rust resistance.
• Oil filled motor housing for lifetime lubrication and rapid heat dissipation.
• Stainless steel screws, bolts, handle and seal assembly
• Mechanical shaft seal (stainless steel spring, nitrile parts, carbon and ceramic faces).
• Automatic operation with integral snap-action float switch has 7" - 10" "On" level range and 2" - 5" "Off" level range.
• Thermal overload protection.

View Specifications

Model Number: 9S-CIA-RFS
Complete With Float Switch.

Calculate Approximate Shipping Cost

Dominator®

Dominator® Wastewater and Sewage Pump - 9S Series

The Dominator® submersible pump series from Little Giant is specifically engineered to handle the tough, demanding tasks of effluent and sewage waste transfer with high efficiency and long term dependability. For use in residential, commercial, industrial and agricultural applications with light to medium transfer demands. Applications include dewatering, effluent waste, wastewater and sewage handling where such materials must be moved upward from a collection area to sewer or septic lines, or drainage areas.

• Handles liquids and 2" diameter solid waste materials.
• Cast iron pump housing with protective epoxy coating for corrosion and rust resistance.
• Oil filled motor housing for lifetime lubrication and rapid heat dissipation.
• Upper sleeve and lower ball bearing construction.
• Stainless steel screws, bolts, handle, and seal assembly.
• Mechanical seals (stainless steel spring, nitrile parts, carbon and ceramic faces).
• Thermal overload protection.
• 2" FNPT Discharge.

View Specifications

Drainosaur® Water Removal System

Includes 5-gallon polypropylene tank. Tank lid has 1 1/2" FNPT (38.1mm) side intake port, 1 1/2" FNPT (38.1mm) top discharge port, and 2" FNPT (51mm) top vent port. Easy-to-remove filter trap. Also includes 3/10 HP automatic submersible sump pump with 8' (2.4m) power cord and 3-prong grounded plug; and 1 1/2" (38.1mm) diameter pipe from pump to lid. Basin is IAPMO approved.

• 3/10HP Shaded Pole Motor
• 46 GPM/174 LPM
• 18'/5.5m Maximum head
• Intermittent Liquid Temp. up to 125°F
• 1 1/2" FNPT (38.1mm) Discharge
• Epoxy coated cast iron housing
• Polycarbonate Cover
• Polypropylene Volute
• Nylon Impeller
• Carbon/Ceramic Shaft Seal
• Upper and lower, Sintered sleeve bearings
• Automatic Operation
• Diaphragm switch Activator
• Switch on - 7" - 10"/17.8cm - 25.4cm
• Switch off - 1" - 4"/2.54cm - 10.2cm
• 115V, 50/60Hz, 9 amps, 8' (2.4m) power cord
• IAPMO Approved Basin